Gas Line Installation & Repair in Folsom, CA

If you smell gas, the distinctive rotten-egg odorant added to natural gas specifically so leaks are noticeable, leave the house immediately, don't operate any light switches or electronics on your way out, and call from outside once you're safely away. Then call your gas utility's emergency line and us. This isn't a situation to wait on, even a small suspected leak warrants leaving the property first and asking questions after.

Gas leaks at the plumbing level usually originate at connection points rather than mid-pipe: a fitting that's loosened over time, a flexible connector to an appliance that's degraded or was improperly installed, or a valve that's failed to seal completely. We use a combustible gas detector to pinpoint the exact leak location rather than guessing based on where the smell seems strongest, since gas travels and pools in ways that don't always match its actual source.

New gas line installation comes up most often around a specific appliance change: adding a gas range where the kitchen previously had electric, installing a gas fireplace insert, or running a line to an outdoor kitchen or fire feature. Each of these requires proper sizing for the appliance's BTU demand, correct pipe material and joint sealing per code, and a pressure test before the line goes into service, not just before it's covered by drywall or buried.

Water heater and furnace gas connections are the most common repair call outside of a full leak, a corroded flexible connector, a shutoff valve that's seized and won't fully close, or a connection that was never properly sealed during a prior installation. We check these as a matter of course any time we're doing water heater work, since a gas connection issue found during an unrelated repair is far better caught early than discovered later.

All gas work we perform is permitted through the City of Folsom where required and inspected before the line is put into service, to California Plumbing Code (UPC-based) gas piping standards. This isn't optional paperwork, it's a genuine safety check on pressure, sizing, and connection integrity that protects you and satisfies insurance and resale requirements down the line.

Any time we install or service a gas appliance, we also check that a functioning carbon monoxide detector is present nearby, since a gas appliance venting improperly is a real and separate risk from a leak at the supply line itself. If your home doesn't have a CO detector near gas appliances or sleeping areas, that's a quick and inexpensive addition worth making alongside any gas line work, not an unrelated upsell tacked onto the invoice. We can install hardwired or battery-powered units during the same visit, so it's one trip rather than a separate appointment for something this important.